MASTER LOCK Datsen Back-up Camera 4843 사용자 설명서

The camera is powered by plugging the camera connector into the vehicle’s towing plug.  

The camera has a 4 position connector which will attach directly to many vehicles and  

has a pass-though design that will allow it to be plugged between the vehicle and trailer.  

Some vehicles may need a 7 position to 4 position adapter 

(figure 5) which is not included.

NOTE: A commonly available 4 position tow wire extension (not included) will allow the  

camera to be mounted farther away from the vehicle plug for gooseneck or fifth wheel  

trailer hitching up applications.

The camera 

1. 

(figure 1) can be mounted inside a 1 ¼” (figure 2) or 2” (figure 3)  

hitch receiver tube. Slide the camera assembly into the hitch tube. The magnet  

in the camera base will hold it securely in place, however the plastic guide on the  

camera bracket will help line the assembly up with the hitch pin opening and allow  

a standard or locking hitch pin to be used for additional security. 
The camera can also be mounted to any metal surface using the magnetic base. 

2. 

(figure 4) 

The soft pads on the base will prevent sliding or scratching and the camera bracket can 

pivot up to 90° to allow the field of view to be adjusted. 

7 Position  
to 4 Position 
Adapter  
Shown

Antenna

Transmitter Housing

 

1-1/4" Tube

2" Tube

Pass thru/T-connector

Guide/Hood