Lenoxx Optima 3 FS 사용자 설명서
SPECIFICATIONS
- Optima 2 FS
PAGE 34
Flue Size
3” / 76mm Rear
Width, Overall
23” / 584mm
Depth, Overall
22 3/4” / 578mm
Depth, Overall w / 3” tee
28 1/2” / 724mm
Height
28
5/8”
/
727mm
Floor to Rear
Flue Center
11 1/4” / 286mm
Facing back of unit,
outside edge of left side
to center of rear
flue outlet center
6 1/2” / 165mm
Floor to Rear
Outside Air Inlet
Located on center-
line of pedestal back
5” / 127mm
Facing back of Unit
outside edge of right side
to center of air inlet
11 1/2” / 292mm
Floor Protection
+ Front and Sides: 6”/152mm
Requirements
Back: Up to 6” / 152mm
Standard Features
Fastfire Self Igniter
Wall Thermostat (wire in-
cluded)
Hopper Capacity
55 lbs.
Burn time
♦ 15-37 hours
Fuse, Control Board
5 Amp, 250 volt, 3AG *
Fuse, Igniter
6 Amp, 125 volt *
Heat Input (BTU’s per hour)
♦ 13,000-32,000 BTU / hr
Overall Efficiency
75-81%
Emissions
♦ 0.4 gr / hr (varies w/size
and type of fuel) EPA ex-
empt.
Shipping Weight
215 lbs.
Room Air Blower
150 CFM; .8 Amps,
2175 rpm
Auger Motor
1 RPM; .4 Amps
Exhaust Blower
95 CFM: 1.0 Amps,
2880 rpm
Fastfire
Igniter
4.35
Amps,
Options
Nickel or Gold Trim Kits
4” Quick Disconnect
Log Set
BACK VIEW
SIDE VIEW
Note: Dimensions shown are approximations only (+/- ¼”)
+
Non-combustible floor protection is required (see
Floor Protection, page 5). When installed at clear-
ances less than 6”, the floor protector is only re-
quired to extend to the wall.
♦ Fuel delivery and burn times will vary depending
on size and type of fuel used. Estimated heat in-
put based on fuel value of 8400 BTU per lb.
*
Fuses are rated as fast blow.
28 1/2"
w/clean-out tee
22 3/4"
23"
28 5/8"
11 ¼"
6 ½"
11 1/2"
8 ¾"
5 1/8"