Lennox Hearth T300P 사용자 설명서

Page 7 

MANUFACTURED (MOBILE) HOME INSTALLATION  
Model –T300P Series 
In addition to the standard installation instructions, the 
following instructions may be required by local, state or 
federal building codes: 
•  Stove must be permanently bolted to the floor.  
•  An outside air inlet must be provided for combustion 

and be unrestricted while unit is in use. 

•  Stove must be permanently electrically grounded to 

the steel chassis of the home. The location selected 
for ground attachment to the stove must be dedicated 
for this purpose.  

•  See pages 10 through 15 for additional information on 

venting requirements. 

•  Do not install appliance in a sleeping room. 
•  The structural integrity of the manufactured home 

floor, walls, ceiling and roof must be maintained. 

 
NOTE: The grounding of this product, at installation, 
must comply with NFPA-70 standards, CSA C22.1 in 
Canada, as well as any local codes. 

 

 

 

Use only listed type “PL” pellet vent pipe. Pipe should 

extend at least 3 feet above the part of the roof through 

which it passes. The top of the pipe should be at least 2 

feet above the highest required elevation of any part of 

the manufactured (mobile) home within 10 feet of the 

pipe. 

 

If the exhaust vent exits the manufactured (mobile) 

home at a location other than the roof, and exits at a 

point 7 feet or less above the ground level on which the 

manufactured (mobile) home is position a guard or 

method of enclosing the pipe shall be provided at the 

point of exit for a height of up to 7 feet. The openings, if 

any, in this guard shall not allow a 3/4” rod to pass 

through. A 1/2” rod could pass through but should not 

be able to touch the pipe when inserted through the 

opening a distance of 4 inches. 

REMOVING APPLIANCE FROM PALLET 
1.  After removing the packaging from the stove, lift the 

hopper lid, and remove all pre-packaged items that 
were shipped in the hopper. Next, open the stove 
door and remove all pre-packaged items. 

2.  Remove screws which secure legs to pallet. 
 
INSTALLING LEG LEVELING BOLTS 
The four leg leveling bolts (included in accessory pack-
age), are provided for leveling the stove if necessary. 
To install, thread the bolts into the existing holes in the 
bottom of each leg. Turn the leveling bolts to adjust for 
correct height. 
 
INSTALLATION CHECK LIST 
It is strongly recommended that you have an authorized 
Lennox Hearth Products dealer install your stove. If you 
install your stove yourself, you should review your in-
stallation plan with your authorized Lennox Hearth 
Products dealer. 
 
Check list: 
Check off each item as you proceed with the installation 
process. 

 

Read the ENTIRE stove installation section first. 

 

Determine the appropriate measurements and loca-
tions for your installation. 

 

Follow the general installation directions under 
Stove Installation and the installation section ap-
propriate to your stove. 

 

Be sure to pre-fit all items before you install, fasten, 
or set up the stove permanently. 

 

Review the safety precaution section. 

 

Review the pellet fuels section. 

 

Review and follow the Operating Instructions. 

 

Plug power cord connector into corresponding con-
nector on the back of appliance (see illustration on 
page 9 showing connector locations). 

 

Review the routine cleaning / maintenance informa-
tion. 

 

Enjoy the warmth from your new Lennox Hearth 
Products pellet stove!