Lanner electronic FW-6420 사용자 설명서

 

 

Both the ISA and PCI buses on the CPU card use system IRQs & DMAs.  You must set up the 
IRQ and DMA assignments correctly through the PnP/PCI Configuration Setup utility, 
otherwise the motherboard will not work properly. 

 

 

 

BIOS Setting and Terms Description 

PnP OS Installed 

Select “Yes” if you are using a Plug and Play capable operating system. Select 
“NO” if you need the BIOS to configure non-boot devices 

Reset Configuration 
Data 

Normally, you leave this field “Disabled”, Select “Enabled” to reset Extended 
System Configuration Data (ESCD) when you exit Setup if you have installed a 
new add-on and the system reconfiguration has caused such a serious conflict that 
the operating system cannot boot. 

Resource Controlled 
By 

The Award Plug and Play BIOS has the capacity to automatically configure all of 
the boot and Plug and Play compatible devices.  However, this capability means 
absolutely nothing unless you are using a Plug and Play operating system such as 
Windows

®98.  If you set this field to “Manual” choose specific resources by 

going into each of the sub menu that follows this field ( a sub menu is proceded 
by a “►”). The settings are “Auto(ESCD)”, “Manual”. 

IRQ Resources 

When resources are controlled manually, assign each system interrupt as one of 
the following types, depending on the type of device using the interrupt. 

These items specify the bus where the specified IRQ line is used. The settings 
determine if Award BIOS should remove an IRQ from the pool of available IRQs 
passed to devices that are configurable by the system BIOS. The available IRQ 
pool is determined by reading the ESCD NVRAM. If more IRQs must be 
removed from the IRQ pool, the end user can use these settings to reserve the IRQ 
by assigning an ISA/EISA setting to it. Onboard I/O is configures by Award 
BIOS. All IRQs used by onboard I/O are configured as PCI/PnP. If all IRQs are