Invacare Electric Portable Patient Lift RPA600-1E 사용자 설명서

다운로드
페이지 40
SECTION 3—OPERATION
16
Closing/Opening the Legs
NOTE: For this procedure, refer to FIGURE 3.2.
WARNING
If the shifter handle is NOT positioned completely into its mounting slot, DO NOT use 
the patient lift until the shifter handle is properly seated and the legs of the patient lift 
are locked in place. Otherwise, injury and/or damage may occur.
WARNING
The legs of the lift must be in the maximum open position and the shifter handle locked 
in place for optimum stability and safety. If it is necessary to close the legs of the lift to 
maneuver the lift under a bed, close the legs of the lift only as long as it takes to position 
the lift over the patient and lift the patient off the surface of the bed. When the legs of 
the lift are no longer under the bed, return the legs of the lift to the maximum open 
position and lock the shifter handle immediately.
Closing the Legs
1. Stand at the rear of the patient lift and grasp the shifter handle with one hand and 
place the opposite hand on the steering handle of the mast for balance.
NOTE: The shifter handle MUST lock into its mounting slot to lock the legs in the full closed 
position. 
2. Pull the shifter handle away from the patient lift and then to your left until it locks in 
the notch of the bracket (Detail “A”).
Opening the Legs
1. Stand at the rear of the patient lift and grasp the shifter handle with one hand and 
place the opposite hand on the steering handle of the mast for balance.
NOTE: The shifter handle MUST lock into its mounting slot to lock the legs in the full open 
position. 
2. Pull the shifter handle away from the patient lift and then to your right (Detail “B”).
FIGURE 3.2   Closing/Opening the Legs
DETAIL “A” - CLOSING THE LEGS
DETAIL “B” - OPENING THE LEGS