Intermate 100 사용자 설명서

You can check the connection by using the enq command to 
place jobs in the queue.

enq -P'psfqueue' -odatat='AFPDS' 

/home/afpjobs/afpguide.afp 

You can also use the command smit psf_data_type_sel to 
enqueue the job.

Check the following areas, if you encounter problems when 
printing from an AIX system and the general troubleshooting 
procedures listed in 

 have not 

helped.

Check the BOOTP setup in the/etc/bootptab file. 

•  Did the print server receive a host name and IP address?

Try to refresh or stop and start the Inetdaemon 
(stopsrc -s inetd and startsrc -s inetd).

Check that the BOOTP server is active.

•  use smit inetdconf to verify.

•  use smit mkinetdconf to append BOOTP.

Are the host name, IP address and hardware address set 
up correctly?

•  see /etc/hosts for host name / IP address relation.

•  use arp -a for hardware address / host name or IP 

address relations.

LPD: Is the queue correctly configured?

•  use smit, qchk, lpq or lpstat.

•  see /etc/qconfig

You may need to refer to the AIX manual Problem Solving 
Guide and Reference, document no. SC23-2204, chapter 8