Hughes HN7700S 사용자 설명서
Chapter 1 • Introduction
1037753-0001 Revision A
3
Commissioning
Commissioning is the process of registering an HN router for
service. During the commissioning process you may use auto
selection or manual entry of parameters.
service. During the commissioning process you may use auto
selection or manual entry of parameters.
• Auto Selection - Allows you to choose the Network Access
Provider (NAP) from a predetermined list of providers. Many
of the commissioning parameters are automatically
configured for the provider chosen.
of the commissioning parameters are automatically
configured for the provider chosen.
• Manual Entry - This mode requires you to enter all
parameters manually.
Associated transport
devices
devices
Installation and commissioning of the HN router requires
configuring/commissioning tasks for the transport device. This
version of the Installation Guide provides information on the
following:
configuring/commissioning tasks for the transport device. This
version of the Installation Guide provides information on the
following:
• ADTRAN Total Access 600R as described in Appendix E –
• Siemens Model 4100/4101 as described in Appendix F –
Safe operating
temperature range
temperature range
5 to 40°C (Above 5000 ft altitude, reduce maximum temperature by 1°C per
1000 ft)
1000 ft)
Safe operating
humidity range
humidity range
5% to 95% non-condensing
Safe altitude
10,000 ft
Cooling method
Convection
Main processor
300 MHz
Main memory
64 Mbyte
Flash memory
16 Mbyte
Protocol support
TCP/IP (Transmission Control Protocol / Internet Protocol) protocol suite
Interfaces/ports
• Two Ethernet ports supporting 10BaseT or 100BaseT operation, RJ45-switched
• Telephone line port
• Serial port, DTE/DCE RS-232, which supports the following protocols:
• Telephone line port
• Serial port, DTE/DCE RS-232, which supports the following protocols:
– VISA (Veriphone 3200 and 3300) (the asynchronous protocol of Vanguard
International Service Association credit card)
– X.25 International Telecommunication Union-Telecommunication
Standardization Sector (ITU-T) protocol standard for WAN communications
– XPAD (X.25 Packet Assembler/Disassembler)
– SDLC (Synchronous Data Link Control)
– LLC (Logical Link Control)
– SDLC (Synchronous Data Link Control)
– LLC (Logical Link Control)
Power supplies and
power requirements
power requirements
Table 1: Specifications for the HN router