HSM Paper Shredder HSM FA 500.2 사용자 설명서
8
0702
FA 500.2
7. Start-up and inspecting the safety
devices
Check that the safety devices are working
properly:
properly:
• At the start of each shift
• After any maintenance or repair work
• After any maintenance or repair work
Do not start the machine until you have
checked the safety devices and found them
to be in perfect working order. If any defect
arises during operation stop the machine im-
mediately and make sure it is corrected.
checked the safety devices and found them
to be in perfect working order. If any defect
arises during operation stop the machine im-
mediately and make sure it is corrected.
Switching on the paper shredder
• Pull out the emergency stop button.
• Solo-version: Turn the main switch to the I
position.
Combination-version: Turn the main switch
on the baling press to the I position.
` The green „Ready for operation“ LED
lights up.
Combination-version: Turn the main switch
on the baling press to the I position.
` The green „Ready for operation“ LED
lights up.
• Press the green start button.
` The cutting block and feed belt start up.
Caution!
The feed belt can run in reverse if the phase
wires in the power plug are incorrectly con-
nected.
wires in the power plug are incorrectly con-
nected.
Turn off the main switch immediately and
pull out the power plug! Have an electrician
change two of the three phase wires.
pull out the power plug! Have an electrician
change two of the three phase wires.
Checking the emergency stop button
Press the emergency stop button
while the machine is running.
The shredder must switch off immedi-
ately. The cutting block and the feed
belt must stop.
The machine will only start again once
you have pulled out the emergency
stop button again.
while the machine is running.
The shredder must switch off immedi-
ately. The cutting block and the feed
belt must stop.
The machine will only start again once
you have pulled out the emergency
stop button again.
Safety fl ap on the feed belt
Open the safety fl ap.
The shredder must switch off immediately and the ”Safety
circuit interrupted” LED must light up.
The shredder must switch off immediately and the ”Safety
circuit interrupted” LED must light up.
The machine will only start again once you have closed
the safety fl ap.
the safety fl ap.
Safety switch on the dust tray
Pull out the dust tray.
The shredder must switch off immediately and the ”Safety
circuit interrupted” LED must light up.
The shredder must switch off immediately and the ”Safety
circuit interrupted” LED must light up.
The machine will only start again once you have pushed
in the dust tray completely.
in the dust tray completely.