HP 288048 사용자 설명서

Before running any paint through the spray gun:

1.

Flush the gun with a solvent that is compatible with 
the fluid to be sprayed, using the lowest possible 
fluid pressure and grounded metal container.

2.

Perform Pressure Relief Procedure; see page 11.

1.

Perform Pressure Relief Procedure; see page 11.

2.

Install the spray tip (H) and the gasket (J) in the tip 
retainer nut (K). Screw the assembly firmly onto the 
gun. Tighten the assembly with a wrench. See F

1.

To adjust the spray pattern direction with fan tips, 
orient the slot in the tip horizontally for a horizontal 
pattern and vertically for a vertical pattern. See Fig. 
7.

2.

Start the pump. Adjust the fluid pressure until the 
spray is completely atomized. Use the lowest pres-
sure necessary to get the desired results. Higher 
pressure may not improve the spray pattern and will 
cause premature tip wear and pump wear.

3.

The spray tip orifice and spray pattern angle deter-
mines the coverage and size of pattern. When more 
coverage is needed, follow the Pressure Relief 
Procedure, page 11, and install a larger spray tip 
rather than increasing fluid pressure.

Select a tip that will supply a stream at the required flow 
rate at the lowest pressure.

Gaskets are included with Streaming Tips 270XXX 
or Fan Tips 182XXX.

TI8577a

K

H

J

TI8170a

TI8196a