HP STORAGEWORKS SSL1016 사용자 설명서

Installation and Configuration

Preparation

Make sure that the work area is free from conditions that could cause electrostatic
discharge (ESD). See Appendix B, “Electrostatic Discharge,” for additional
information. You will need a #2 Phillips screwdriver for rackmount installations.

SCSI Bus Requirements

The autoloader contains a SCSI interface that supports both Single Ended (SE)
and Low Voltage Differential (LVD) communication, however, data transfer rates
and SCSI cable lengths will be reduced if an SE connection is used. The
autoloader is not compatible with a High Voltage Differential (HVD) SCSI bus.

The following SCSI host adapter cards are currently supported on the autoloader:

Note:

For best performance, an LVD connection is recommended.

Table 2: Supported Adapters

Adapter

DLT1

SDLT 320

Ultrium 460

64-bit/66 MHz Dual Channel Wide

Ultra3 SCSI adapter (LVD)

yes

64-bit/66 MHz Single Channel Wide

Ultra3 SCSI adapter (LVD)

yes

64-bit Dual Channel Wide Ultra2 SCSI

adapter (SE and LVD)

yes