Hotpoint Outdoor Gas Burner GX 641 F G X 사용자 설명서

다운로드
페이지 16
GB
7
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Gas connection
The appliance should be connected to the main gas 
supply  in compliance with current national regulations. 
Before carrying out the connection, make sure the cooker 
is compatible with the gas supply you wish to use: G20-
20mbar (Natural Gas).
! Check that the pressure of the gas supply is consistent 
with the values indicated in Table 1 (“Burner and nozzle 
specifications”). This  will  ensure  the  safe  operation  and 
longevity  of  your  appliance  while  maintaining  efficient 
energy consumption.
Connection with a rigid pipe (copper or steel)
! Connection to the gas system must be carried out in such a 
way as not to place any strain of any kind on the appliance.
There is an adjustable L-shaped pipe fitting on the appliance 
supply ramp and this is fitted with a seal in order to prevent 
leaks. The seal must always be replaced after rotating the 
pipe fitting (seal provided with appliance). The gas supply 
pipe fitting is a threaded 1/2 gas cylindrical male attachment.
Connecting a flexible jointless stainless steel pipe to a 
threaded attachment
The gas supply pipe fitting is a threaded 1/2 gas cylindrical 
male attachment.
These pipes must be installed so that they are never longer 
than 2000 mm when fully extended. Once connection has 
been carried out, make sure that the flexible metal pipe 
does not touch any moving parts and is not compressed.
! Only use pipes and seals that comply with current national 
regulations.
Checking the tightness of the connection
! When the installation process is complete, check the pipe 
fittings for leaks using a soapy solution. Never use a flame.
! Should the gas pressure used be different (or vary slightly) 
from the recommended pressure, a suitable pressure 
regulator must be fitted to the inlet pipe (in order to comply 
with current national regulations).
Electrical 
connections
DATA PLATE
see data plate
This appliance conforms to the following 
European Economic Community directives:
- 2006/95/EEC dated 12/12/06 (Low 
Voltage) and subsequent amendments
- 2004/108/EEC dated 15/12/04 
(Electromagnetic Compatibility) and 
subsequent amendments
- 93/68/EEC dated 22/07/93 and 
subsequent amendments.
- 2009/142/EEC dated 30/11/09 (Gas) and 
subsequent amendments.
- 2012/19/EC and subsequent 
amendments.