Honeywell Marine Instruments YP7999A1000 사용자 설명서

66-2060—01

2

Components are individually approved by the nationally rec-

ognized agencies. Please see component literature for 

details. The panel has UL 508A flame control panel 

approval. Panel is assembled and wired to the UL Stan-

dards.

1. Read these instructions and the appropriate product lit-

erature carefully. Failure to follow them could damage 

the product or cause a hazardous condition.

2. Refer to the installation manuals and wiring diagrams 

provided with this panel for the embedded products.

3. Check the ratings given in the instructions and on the 

product to make sure that the product is suitable for your 

application.

4. Installer must be a trained, experienced combustion ser-

vice technician.

5. Disconnect the power supply before beginning installa-

tion to prevent electrical shock and equipment damage. 

More than one disconnect may be involved.

6. All wiring must comply with the National Electric Code 

(NEC) and any applicable local electrical codes, ordi-

nances and regulations.

7. After installation is complete, check out product opera-

tion as provided in the appropriate product installation 

instructions.

To prevent possible hazardous burner operation, verify 

safety requirements each time a controller is installed 

on a burner.

Disconnect the power supply before beginning wiring 

to prevent electrical shock, equipment and control 

damage. More than one disconnect may be involved.

Earth ground is required for proper operation of the 

ControLinks system. The earth ground must be capable of 

conducting enough current to blow the fuse or breaker in the 

event of an internal short. Ensure the panel is bonded to a 

substantial earth ground. Make sure that mechanically 

tightened joints along the ground path are free of 

nonconductive coatings and protected against corrosion on 

mating surfaces.

1. Refer to the appropriate product data sheet for details.

2. Wire size and length will vary, depending on the compo-

nent. Refer to the component literature for specific wire 

lengths, sizes and type recommendations.

3. Wire according to specifications, following all local ordi-

nances and requirements.

4. Field knockouts are required for the wiring. When drill-

ing holes, take care to protect the electronics from metal 

pieces and debris. 

After mounting and wiring, but before powering the panel, 

inspect all internal panel wire connections. Each panel is fully 

tested at the factory; however, wires may loosen during transit. 

Verify that all internal wire connections are secure from the 

Q7999 subbase to the components mounted on the door and 

the S7999D touchscreen interface.

All wiring shall be in accordance with the National Electric 

Codes (NEC) and local electrical codes.

1. Check the power supply circuit. The voltage and fre-

quency must match the specification listed.

2. Check wiring terminations and routing to ensure proper 

connections.

3. Follow any system checkout recommendations for indi-

vidual components as found in the component literature.

4. Restore power to the panel.

Can cause serious injury, death or equipment 

damage.

1. Close all manual fuel shutoff valves before starting 

these tests.

2. Use extreme care while testing the system. Line voltage 

is present on most terminal connections when power is 

on.

3. Replace all limits and interlocks that are not operating 

properly. Do not bypass limit and interlocks.