Hitachi WIRELESSIP TD61-2472A 사용자 설명서

If you connect your WirelessIP5000 to a PC with the USB cable shown in Figure 3, you can 
charge and change settings. 

When setting the WirelessIP5000, check whether your WirelessIP5000 is directly connected 
to your PC with the USB cable. 

 

Load the battery into the battery installation section at the rear of the WirelessIP5000, then  
push in, in the direction of the release button until it clicks into place. 

While holding down the release button, pull the battery toward the bottom of the WirelessIP
5000 and remove it. 

Step 1:  Plug the AC adaptor into a wall socket, then connect the connector to the rear of the  
 battery 

charger. 

 
Step 2:  As displayed in Figure 4, place the WirelessIP5000 into the top of the charger and push  
 

until it clicks into place and the blue LED turns on. 

 

 

Figure 4 

 
 
 
Note:   As Figure 5 shows, you can also charge with the optional USB cable instead of with the

 AC adaptor.