GenTran POWER STAY 6370C 전단

Thank you for purchasing this Parallel Power Kit.  Do not return this product 
to the store!  If any parts are missing or damaged, please contact us toll free 
at 1-888-GEN-TRAN or visit our website at www.gen-tran.com. This product is 
intended for use with two Honda EU3000i generators ONLY.  Do NOT attempt 
to parallel two unlike generators!  For 125 Volt Use Only.

TOOLS NEEDED FOR ASSEMBLY:

10 mm socket wrench or nut driver
11/32 nut driver

HARDWARE INCLUDED:

(2) 8/32 Nylok nuts
(2) M6-35 Standoffs

STEP 1
NEVER connect Parallel Power Kit while generator is 
running!  Using the 10 mm socket wrench, remove the four 
(4) cap nuts on the end of the generator, and set aside.

STEP 2
Mount Parallel Power Kit mounting plate on two bottom 
studs, and reattach bottom two cap nuts loosely.

STEP 3
Insert two standoffs into the two upper holes, and 
hand tighten.

STEP 4
Attach support bar with recesses over the standoffs.  
Reattach the remaining two cap nuts over the standoffs, 
and hand tighten.  Then attach two Nylok nuts onto the 
studs protruding from the mounting plate to secure the 
support bar.  Tighten all nuts moderately using a tool.

Configuration of receptacle

50 amps, 125 V

(L6377)