Genesis Advanced Technologies Saw GTS10S 사용자 설명서

English

10" Table Saw           

 

  

Operator’s Manual      

 

 GTS10S

Saw will not start

1. Saw is not plugged in

1. Plug to power source

2. Fuse blown or circuit breaker 

2. Replace fuse or reset circuit break.

3. cord is damaged

3. Have power cord replaced by Authorized 

4. Debris in ON/OFF switch

4. Clean any debris accumulated

Does not make accurate 45°  1. Positive stop not adjusted 

1. Check the blade with square and adjust 

2. Blade angle pointer not set 
accurately

2. Check blade with square and adjust the 
Blade angle pointer

Material Pinched Blade when  1. Rip fence not aligned with blade 1. Check and adjust the rip fence

2. Warped wood, edge against 
fence is not straight

2. Select another piece of wood

Material Binds on Splitter

1. Splitter not in line correctly with 
blade

1. Check and align the splitter with blade

Saw makes unsatisfactory 

1. Dull Blade

1. Replace blade

2. Blade mounted backward

2. Turn blade around

3. Gum or resin on blade

3. Remove blade and clean

4. Incorrect blade for work

4. Change to correct blade

Material Kicked Back from the  1. Rip  fence out of adjustment

1. Align rip fence with miter gauge groove.

2. Splitter not in line with blade

2. Align splitter with blade

3. Feeding stock without rip fence

3. Install and use rip fence

4. Dull blade

4. Replace blade

5. Bevel Knob is not tight

5. Tighten the knob

Blade does not raise or tilt 
freely

1 Sawdust and dirt in 
elevation/tilting mechanisms

1. Brush or blow out loose dust and dirt

Blade does not come up to 

1. Extension cord is too light or too  1. Replace extension cord to adequate size
2. Low house voltage

2. Contact electrician

Saw vibrates excessively

1. Saw not mounted securely to 

1. Tighten all mounting hardware

2. Bench or stand on uneven floor 2. Re-position on flat level floor
3. Damaged saw blade

3. Replace blade

This product is warranted free from defects in material and workmanship for 2 years after date of purchase. This limited warranty does not cover
normal wear and tear or damage from neglect or accident. The original purchaser is covered by this warranty and it is not transferable. Please return
the tool to store location of purchase along with your receipt, and you will receive a new drill or a refund.

For questions about this or any other GeNeSIS Product, please call Toll-Free:

.

Or visit our website: