Edelweiss EQ1-DYN 사용자 설명서

Daniel Weiss Engineering Ltd., Florastr. 42, CH-8610 Uster 

Page  6 of 27

)

 +41 1 940 20 06    2 +41 1 940 22 14  

8

 http://www.weiss.ch 

*

 weiss@weiss.ch

The status display consists of four groups display-

ing audio signal properties and information about

the current state of the EQ1. The groups are

situated adjacent to the softkeys to the right of

the LCD (Graph 2).

Situated adjacent to key A, displays the following

information:

 

sampling frequency in kHz: “44.1”, “ 48”,

“88.2” or “96”

 

pre-emphasis: “E” appears if pre-emphasis

is set (empty if not used)

 

input   output channel status data format:

“C” for consumer and “P”  for professional

To change the output channel status data format,

press key A and select format type or loop

through.

Situated adjacent to key B, this group contains a

peak-hold and an over-hold for each channel. To

reset these values press key B twice.

Peak-Hold

The numeric peak value is measured relative to

0dBFS, where 0dB equals digital full scale.

Use this value to set the optimal gain for a specific

session. Reset it for every session.

Over-Hold

Whenever an over is encountered, the boxes to

the side of the peak-hold values are marked.
The functions of the over-LED’s and the over-

hold both depend on the 

NUMBER OF

CONSECUTIVE OVER-SAMPLES 

setting. To adjust this

setting, press key B once. Use the “gain/ data”

encoder to change the value, then press “menu”

to return to the status display.
This setting defines the number of consecutive

over-samples needed for an over-indication. To

indicate every over-sample, enter 1. If another

value is entered, you are still able to detect a sin-

gle over-sample with the peak-hold function.

Situated adjacent to key C, displays remote con-

trol protocol (“MIDI”, “RS 232” or “RS 422”),

channel (“1” - “16”) and status (on/ off, displayed

with check box).
For remote control set-up see chapter Remote

Control.

Key B

Key C

Key A

Key D

Key C