Cub Cadet 59A40003727 서비스 매뉴얼

10. Your Cub Cadet Yanmar dealer can supply original equipment 

hydraulic accessories and repair parts. Substitute parts 
may not meet original equipment specifications and may be 
dangerous.

11. Ensure implement is properly attached, adjusted and in good 

operating condition.

12. Power unit must be equipped with ROPS or ROPS CAB and 

seat belt. Keep seat belt securely fastened. Falling off power 
unit can result in death from being run over or crushed. Keep 
foldable ROPS systems in locked up position at all times.

13. Ensure all safety labels are installed. Replace if damaged. 

(See Safety Labels later in this section).

14. Ensure shields and guards are properly installed and in good 

condition. Replace if damaged.

1.  Do not allow other people in the area when operating, attach-

ing, removing, assembling or servicing equipment.

2.  Improper use of a loader can cause injury or death.
3.  Consult local utilities before working. Know location of and 

avoid contacting all underground cables, pipelines, overhead 
wires and other hazards in working area.

4.  Do not attempt to lift loads in excess of the loader capacity.
5.  Keep bystanders away from equipment.
6.  Do not walk or work under a raised loader, bucket or attach-

ment.

7.  Never allow anyone to get under the loader bucket or reach 

through the lift arms when the bucket is raised.

8.  Do not operate equipment while under the influence of alcohol 

or drugs.

9.  Operate only in daylight or good artificial light.
10. Always comply with all state and local lighting and marking 

requirements.

11. Do not allow riders. Do not lift or carry anybody on the loader 

or in the bucket or attachments.

12. Power unit must be equipped with ROPS or ROPS CAB and 

seat belt. Keep seat belt securely fastened. Falling off power 
unit can result in death from being run over or crushed. Keep 
foldable ROPS systems in “locked up” position at all times.

13. Always sit in tractor seat when operating controls or starting 

engine. Securely fasten seat belt, place transmission in 
neutral, engage brake and ensure all other controls are 
disengaged before starting tractor engine.

14. Look down and to the rear and make sure area is clear before 

operating in reverse.

15. Avoid loose fill, rocks and holes. They can be dangerous for 

loader operation or movement.

16. Allow for loader length and width when making turns.

17. Stop the loader arms gradually when lowering or lifting.
18. Use caution when handling loose or shiftable loads.

•  Move and turn tractor at low speeds.
•  Watch for hidden hazards such as holes, ditches, and other 

obstructions which may cause tractor and loader to tip over.

•  Carry loads close to the ground to aid visibility and lower 

center of gravity for improved stability.

•  Balance loads so weight is evenly distributed and load is 

stable.

•  Be extra careful when operating on a slope.
•  Do not operate on steep slopes.
•  Do not stop, start or change directions suddenly on slopes.
•  If loader is equipped with round bale attachments, always 

approach bale with tractor facing uphill.

•  Tractor must be equipped with a Roll-Over Protective 

Structure (ROPS) and seat belt.

•  Keep seat belt securely fastened and keep foldable ROPS 

systems in “locked up” position at all times.

•  Stay away from power lines. Electrocution can occur without 

direct contact.

•  Check clearances before raising loader.
•  Consult local utilities before digging. Know location of and 

avoid contacting all underground cables, pipelines, overhead 
wires and other hazards in digging area.

•  Do not leave the operator’s seat if any part of the tractor or 

loader contacts electric lines or underground cables.

•  This loader is not equipped with any method to prevent 

objects such as round bales, posts, logs, etc. from rolling 
back onto operator.

•  Do not carry large objects that can fall out of loader bucket 

into operator zone.

•  Never lift loader higher than necessary to clear the ground 

when moving.

•  Before dismounting tractor or performing any service or 

maintenance, disengage the power to the implement, lower 
the 3-point hitch and all raised components to the ground, 
operate valve lever to release any hydraulic pressure, stop 
engine, set parking brake, remove key, and unfasten seat belt.

•  Never work under a raised loader. Always lower loader to the 

ground with bucket or loader attachment in full roll-back posi-
tion. Shut off tractor, set park brake and remove key. Operate 
valve levers to release any hydraulic pressure. If loader 
obstructs tractor maintenance, loader must be removed from 
tractor.