Country Home Products Garden Cart 사용자 설명서

 

 

CALL TOLL FREE 1-866-NEUTON1 

     

13

• 

  Open the blue hardware bag.  Insert a 1/4" x 1/2" screw through each of the holes in the rim of the lower 

bucket (Figure 1). 

• 

  Tighten the center two screws first using a Phillips screwdriver.  The ends of the buckets will now more 

easily align.  Then tighten the remaining four screws.  Be careful not to over-tighten the screws. 

Tip:   Tighten the screws until they are just snug.  Don’t press down too hard or tighten the screws too much.  

This can cause the threaded inserts (in the upper bucket) to loosen and spin freely.  If an insert does 
loosen, push it back in and lock it into its recessed position.  Then you can tighten the screw again.

 

Now, attach the entire drive train and battery                                                                                                
to the bucket assembly. 

• 

   Lift the drive train assembly and place it onto the 

lower bucket (Figure 2).    

• 

   Face the wire harness and the battery door towards 

the rear mounting plate (attached to lower handle 
assembly).  Make sure that the wire harness is 
routed through the slot in the drive train housing. 

 

 

 

 

 

 

 

 
DO NOT PLACE THE DRIVE TRAIN ON TOP OF THE WIRE HARNESS. 

 

Line up the drive train’s holes with the lower bucket’s receiving holes.  The receiving holes on the lower 
bucket have threaded inserts already in them.  

Tip:   Make sure the drive train is seated properly on the lower bucket before inserting the screws. There 

is a specific position that the drive train lines up with.  Again, you can look in the holes in the drive 
train assembly to see when it aligns properly. 

 

• 

   Open the green hardware bag.  First place a 1/4" lock washer on the 1/4" x 1-1/2" screw, then a 1/4" 

small flat washer.

 

 Insert the screws and washers through each of the holes (Figure 2). 

• 

   Use your hands to align and loosely screw in the screws.  Once all four are loosely screwed in, tighten 

them down snugly with a Phillips head screwdriver.  Again, don’t over-tighten them.