Funai FDP-100 사용자 설명서

8

Connection to Power (For UK)

Before Switching on make sure that the voltage of your electricity supply is the same as that 
indicated on the rating plate.

‹

This appliance may be fitted with a non-
rewireable plug. If it is necessary to change 
the fuse in a nonrewireable plug the fuse 
cover must be refitted. If the fuse cover is 
lost or damaged, the plug must not be used 
until a replacement available from the 
appliance manufacturer is obtained.
It is important that the colour of the 
replacement fuse cover corresponds with the 
rating marking on the base of the plug.
If the plug has to be changed because it is 
not suitable for your socket, or becomes 
damaged, it should be cut off and an 
appropriate plug fitted following the wiring 
instructions below. The plug removed must 
be disposed of safely as insertion into a 13A 
socket is likely to cause an electrical hazard.
For your own safety read the following 
instructions carefully before attempting to 
connect this unit to mains.
The wires in this mains lead are coloured in 
accordance with the following code:

BLUE=NEUTRAL, BROWN=LIVE

‹

As the colours of the wires in the mains lead 
of this appliance may not correspond with 
the coloured markings identifying the 
terminals in your plug, proceed as follows:
The wire which is coloured blue must be 
connected to the terminal which is marked 
with the letter N or coloured black.
The wire which is coloured brown must be 
connected to the terminal which is marked 
with the letter L or coloured red.
No connection is to be made to the earth 
terminal of the plug.
If a 13 Amp (BS 1363) Plug is used, a 3 Amp 
Fuse must be fitted, or if any other type of 
Plug is used a 3 or 5 Amp Fuse must be 
fitted, either in the Plug or Adaptor, or on the 
Distribution Board.
Mains Supply:220 - 240 V

 50 Hz - AC only

Do not make any connection to the larger pin 
marked with the letter “E” or by the symbol 

 or coloured green or green and yellow.