Fujitsu CONNECT2AIR AP-600RP-USB 사용자 설명서
Inform WLAN AP-600RP-USB Configuration schemes Issue October 16
th
2003
Page 4 of 6
5.
AP-600RP-USB with ADSL Modem
( 1 ) ADSL Modem
( 2 ) AP-600RP-USB
( 3 ) Notebook
No configuration necessary
WAN:
PPP over Ethernet
LAN:
static IP: 192.168.1.254
DHCP
on: 192.168.1.10 - 90
GW:
192.168.1.254
DNS:
auto
SSID: CONNECT2AIR
TCP/IP:
get IP and DNS
address
automatically
SSID: CONNECT2AIR
Data Rate: auto
SSID: CONNECT2AIR
Data Rate: auto
Connecting the devices to the AP-600RP-USB:
Connect the ADSL Modem to the WAN port, otherwise the PPPoE session cannot be established and therefore the
Internet service cannot be opened. Additional networking devices like network printers, servers or scanners can be
plugged to one of the free LAN ports and will be integrated in the IP segment of 192.168.1.X.
Internet service cannot be opened. Additional networking devices like network printers, servers or scanners can be
plugged to one of the free LAN ports and will be integrated in the IP segment of 192.168.1.X.
Installation Note
Most broadband Internet connections are nowadays established over an ADSL Modem. This case describes using an
ADSL modem in connection to the WLAN AccessPoint. The configuration is quite easy and allows you to share one
single Internet connection with several other Clients.
Important: Please check thoroughly if you do have a Modem or a Router, due to the complete different configuration.
4
1
2
1
3
4
3