Fujitsu 2300 사용자 설명서

 Using the Stylistic 2300 Pen Tablet

Charging the Battery Pack

2

The Stylistic 2300 battery pack can be charged while it is installed in the pen tablet. 
To do so: 

1. Connect a DC power source, such as the AC adapter, to the DC input connector 

on the pen tablet. The DC Input icon appears in the Status display. If the battery 
pack charge level is below 90%, the battery pack begins charging and the 
Charging icon appears in the Status display. If the battery pack charge is 90% or 
higher when you connect DC power, the battery pack will not charge; this prevents 
overcharging the battery pack. 

2. Look at the Battery Gauge icon in the Status display to determine the percent of 

charge in the battery pack. See “Status Display” in Chapter 1 of this manual for a 
description of the Battery Gauge icon.

As long as DC power remains connected to the pen tablet, the charging process 
continues until the battery pack charge reaches 100%. Charge times shown in Table 
2-2 are for a fully discharged battery pack charging both while the pen tablet is and is 
not in use. 

Table 2-2   Battery Pack Charging Time  

Also note the following with respect to charging the battery pack: 

• You can use the system, suspend system operation, or shut down and turn off the 

system without interrupting the charging process; however, using the system 
while the battery pack is charging will cause the battery pack to charge at a slower 
rate, as noted in Table 2-2.

• As noted in the procedure above, the system will not begin charging the battery 

pack if the battery pack charge level is 90% or higher when the system is initially 
connected to external DC power. (This prevents the battery pack from being 
overcharged.) 

90%

3 hours 

9 to 10 hours

100%

5 hours

12 hours