Contax i4R 사용자 설명서
EN-31
Turning the Camera On
1
Slide the lens cover towards the outer edge, as shown in the
illustration.
Slide the lens cover until it clicks (approximately 18 mm), then continue to slide it towards the outer edge
until it stops (approximately 2 mm), then release the cover. The lens moves out of the camera and the
startup screen is displayed on the LCD monitor.
until it stops (approximately 2 mm), then release the cover. The lens moves out of the camera and the
startup screen is displayed on the LCD monitor.
Turning the Camera Off
1
Slide the lens cover towards the outer edge until it stops
(approximately 2 mm), then release the cover.
The camera stores the lens and the message "CLOSE LENS COVER" appears on the LCD monitor.
The LCD monitor then turns off.
The LCD monitor then turns off.
A
Important
Check that a memory card is inserted in the camera before turning the camera on.
B
Note
You can configure whether the camera starts in still image mode when it is turned on or if it
returns to same mode as when it was turned off. (Æ p.179)
returns to same mode as when it was turned off. (Æ p.179)