Fortress Technologies FS-30 사용자 설명서

다운로드
페이지 14
 
OPERATING INSTRUCTIONS 
 
EMERGENCY OVERRIDE / DISARM 
If  you  have  lost  the  transmitter  or  it  stops  working  for  any  reason  and  the  Alarm  is  armed,  you  will  have  to 
open the door with the key, which will activate the alarm.  Turn the ignition on and press the override/program 
button  for  about  5  seconds  (until  siren  stops).    The  Alarm  will  disarm.    If  you  continue  to  hold  the  button  for 
additional 7 seconds, the system will enter the Valet mode. 
 
EMERGENCY DISARM WITH CUSTOM OVERRIDE 
Custom override allows the user to set a specific number of button presses (2-15) required to perform an 
emergency override/disarm of the alarm system.  This increases the level of security of the system, but you 
MUST MEMORIZE how many button presses you have changed your system to use or the unit will not disarm 
in an emergency. 
 
1.  Enter programming mode.  
2.  Turn the Ignition ON and press the Override/Program button 5 times. 
3.  After a short delay, the parking lights will flash 5 times, Siren 5 times, Horn 5 times and status LED will be 
on solid. 
4.  Press program button three times to go to option #3 “Passive Locks/Custom Override”. 
5.  Press Button 3 (trunk) on the remote transmitter (3 chirps). 
6.  Press and release the program again the number of times you desire in order to perform emergency disarm 
on this alarm system.  Press the program button 2-15 times only.  You need to wait for the siren to chirp the 
same number of times you pressed the program button to confirm. 
 
To test feature:  Trip the alarm system, turn key ON, press the program/valet button 2-15 times as 
programmed above then continue to HOLD DOWN valet button on the LAST PRESS for 5 seconds.  Alarm 
should disarm.  If system does not disarm, then disarm with the remote transmitter and try again.  If system 
still does not disarm or you have forgotten your custom code, then you must use your remote control to disarm 
the system. 
 
CAUTIONARY NOTE! 
If you set up this feature and forget your special code, there is no way to disarm the system other than the 
remote control. If you have programmed your system for Custom Override, follow the same steps above 
(Emergency Override) while pressing the valet button 2-15 times as you have programmed.  You must 
continue to hold the button down on the last press for 5 seconds.  The Alarm will disarm and enter the Valet 
mode, which allows you to use the vehicle until you can repair/replace the remote transmitter or have the 
alarm system checked.