Clarion DXZ538R 사용자 설명서

DXZ538R

Power does not turn 
on. 
(No sound is pro-
duced.)

No sound output 
when operating the 
unit with amplifiers or 
power antenna at-
tached.

Nothing happens 
when buttons are 
pressed.

Display is not accu-
rate.

Fuse is blown.

Incorrect wiring.

Power antenna lead is shor-
ted to ground or excessive 
current is required for re-
mote-on the amplifiers or 
power antenna.

The microprocessor has 
malfunctioned due to noise, 
etc.

DCP or main unit connec-
tors are dirty.

Replace with a fuse of the same amperage. If 
the fuse blows again, consult your store of 
purchase. 

Consult your store of purchase.

1. Turn the unit off.
2. Remove all wires attached to the power 

antenna lead. Check each wire for a possible 
short to ground using an ohm meter.

3. Turn the unit back on.
4. Reconnect each amplifier remote wire to  the 

power antenna lead one by one. If the 
amplifiers turn off before all wires are 
attached, use an external relay to provide 
remote-on voltage (excessive current 
required).

Turn off the power, then 
press the [OPEN] button 
and remove the DCP.
Press the reset button for 
about 2 seconds with a 
thin rod.

Wipe the dirt off with a soft cloth moistened with 
cleaning alcohol.

Reset button

Compact disc cannot 
be loaded.

Sound skips or is noi-
sy.

Sound is bad directly 
after power is turned 
on.

Another compact disc is al-
ready loaded.

Compact disc is dirty.

Compact disc is heavily 
scratched or warped.

Water droplets may form on 
the internal lens when the 
car is parked in a humid 
place.

Eject the compact disc before loading the new 
one.

Clean the compact disc with a soft cloth.

Replace with a compact disc with no scratches.

Let dry for about 1 hour with the power on.