Ciprico Rimfire 3880 사용자 설명서

The amber LED is used to indicate an error condition. These are the conditions 
indicated by the amber LED:

 - This indicates that the adapter has had a self-test failure.

 - This indicates that the board has had a catastrophic 

error during operation such as bus error or timeout. The Status port will contain 
an error code that details the type of failure that occurred. These error codes are:

Code

Name

Description

10H

Bad PBIN or SBOUT 

Value

The Command List PBIN or SBOUT value exceeded the 
value set for PBNUM or SBNUM.

11H

State wrong for Start/

Stop Command List 

command

The code is returned under these conditions:

 command issued a command list is 

already active.

 command issued when no command 

list is presently active.

 issued when no 

Command List is active.

12H

Target Mode Error

A 

 Channel Attention 

issued when no selection are was written by adapter.

14H

Software VMEbus 

Timeout

The adapter times each of its VMEbus transfers; it will report 
this if a VMEbus transfer takes too long to complete. This 

can occur for transfers of parameters as well as data.

15H

VMEbus Error Occurred

A VMEbus error was detected while the adapter was 
transferring either parameters or data.

96H

Internal Firmware Error This error code indicates that a Firmware error was detected 

during the execution of a command.