Canon Microfilm Scanner 300 사용자 매뉴얼

21

■ BEFORE YOU BEGIN ... ■

This is a summary of the keys on the operation panel.

1 Negative/Positive key

Three settings are available:

( 

 ) In negative film mode produces positive output from nega-

tive film images.

( 

 ) In positive film mode, produces positive output from posi-

tive images.

( A ) In automatic mode, selects the mode based on the type of

film detected.(

➞P.33)

2 Trimming/Border key

Use this key to trim the image to be scanned or to remove the

black border around the image.(

➞P.34)

3 Brightness indicator

Shows the brightness adjusted using the brightness adjustment

key.

4 Brightness adjustment keys

Use the   or   key to adjust brightness of the image manually,

or the use AE key to adjust it automatically. In the DMP mode,

this applies to brightness for printing.

5 Print/Error Display

Displays the number of prints (01 to 99) in case of the Reader-

Printer mode. Also displays error message(User and Service

releated).

6 Print number setting key

Use these keys to set the number of prints to make for each

image in the Reader-Printer mode or the DMP mode (

➞P.11).

Also use them to set various settings or confirm the SCSI ID of

the scanner.

7 Clear/Stop key

Stops scanning or resets the number of prints. Also defines an

area for trimming, or defines a specified time for the power

saver mode.

When the scanner is connected to the Fileprint 450 and used in

the DMP mode, this key is also used to switch to the cassette

select mode (

➞P.36).

8 Start key

In the case of the Scanner mode: press this key to start scan-

ning with the “Panel Start” set to on in the application, or to

start scanning in the Reader-Printer mode (

➞P.11).

In the case of the DMP mode: press this key to start printing.

The Print/Error display stays blinking from the time the key is

pressed until the time scanning begins.