Axxess Interface OESWC-8113-STK 사용자 설명서

8.  Make sure the steering wheel control buttons function correctly in the 

vehicle and enjoy your radio.

If the ASWCSTALK is mounted on the right side of the steering column 

follow the instructions below. (Auto-detect must be done first)

1. 

Turn the ignition on

2. 

Press the MODE on the ASWCSTALK for 10 seconds

3. 

Then press volume up for 2 seconds

4. 

The ASWCSTALK is now configured for the right side.

So you tried the auto detect feature and at the end the led did not stay on 

solid red, it started flashing, or the steering wheel controls did not function 

properly. That means the interface did not detect the ASWCSTALK or the 

proper radio. Follow these steps to determine what happened:

First some basic tips:
1.  Verify that you have 12 volt accessory and a good ground to the 

ASWCSTALK and interface.

2.  Verify that the 3.5mm connector is connected to your radio securely 

and in the correct location.

3.  If using the female 3.5mm connector on an Eclipse or Kenwood radio, 

verify that the radio’s SWC wire is connected to the correct wire on 

the interface.

Once all the information above has been verified and correct, you 

will need to put the interface back into auto-detect mode. Follow the 

instructions from “If the ASWCSTALK was installed before” section above, 

however this time take notice of the led flashes in steps 5 and 6.