Avaya S8710 사용자 설명서

Configuring the media server

A new media server comes with a blank hard drive and a bootable CD-ROM with Linux operating system 
and Release 2.1 of Avaya Communication Manager on it.

Use the instructions in

Quick Start for Hardware Installation: Avaya S8700 or S8710 Media Server (555-

245-703) to install the media servers in the data rack. After installing the media servers, you must install 
the software from the CD onto the hard drive of each media server.

This section covers the following tasks:

Make sure you have the filled-out Electronic Preinstallation Worksheet (EPW) before 
beginning this process.

Make sure your networking and Web browser settings are correct. See Appendix A, 

Depending on your laptop computer’s operating system (generally Windows 2000), you 
may need to clear the Address Resolution Protocol (ARP) cache before entering a new IP 
address. If you enter an IP address, and your computer cannot connect, then you may need 
to clear the cache.

On your laptop computer click Start > Run to open the Run dialog box.

Type 

 and press Enter

to open a MS-DOS Command Line window.

Type 

 and press Enter

to clear the Address Resolution Protocol (ARP) cache in 

the laptop. This command responds with one of the following:

The command line prompt when the cache has been cleared.

The phrase: 

The specified entry was not found.

 

This is returned when the specified IP address does not currently appear in the ARP cache.