Audio Power DSP System Multiface 사용자 설명서

 

 
60                            

User's Guide HDSP System Multiface II

 © RME

 

 

 
The Monitor panel provides several options usually found on analog mixing desks. It offers 
quick access to monitoring functions which are needed all the time in typical studio work. 
 
Monitor Main 
Use the drop down menu to select the hardware outputs where your main monitors are con-
nected to. 
 
Dim 
A click on this button will lower the volume of your main monitor output (see 
above) by an amount set up in the Preferences dialog (see below). This is the 
same as moving the third row faders down a bit, but much more convenient, as 
the old setting is back by a simple mouse click. 
 
Mono 
Sets the stereo output defined above to monaural playback. Useful to check for 
mono compatibility and phase problems. 
 
Talkback 
A click on this button will dim the Main Monitor output (see above) by an amount 
set up in the Preferences dialog. At the same time the control room's microphone 
signal (source defined in Preferences) is sent to the three destinations described 
below as Monitor Phones. The mic level is adjusted with the channel's input fader. 
 
Monitor Phones 1/2/3 
Use the drop down menu to select the hardware outputs where the submixes are sent to. These 
submixes are usually phones mixdowns for the musicians. A click on the button allows to hear 
the specific submix via the Main Monitor outputs. So when setting up or modifying the submix 
for the musician this process can be monitored easily and any time. Or in other words: you can 
easily check other hardware outputs/submixes by using the Monitor Phones function, without 
the need to copy/paste routings back and forth, or to reconfigure the cabling at the hardware. 
 
 

 
The dialog box Preferences is available via the menu 
Options or directly via F3. 
 
Talkback 
Input: Select the input channel of the Talkback signal 
(microphone in control room). 
Dim: Amount of attenuation of the Main Monitor output in 
dB. 
 
Listenback 
Input: Select the input channel of the Listenback signal 
(microphone in recording room). 
Dim: Amount of attenuation of the Monitor Phones out-
puts in dB. 
 
Note: The Mute button of the Talkback and Listenback 
channel is still active. Therefore it is not necessary to 
select <NONE>, in case one of both shall be deacti-
vated. 
 
MIDI Controller, Full LC Display Support 
See chapter 31.3 for details.