Antunes, AJ VS-350 사용자 설명서
Variety Steamer
4
P/N 1010745 Rev. g 03/06
throughout this manual, you will find the following safety words and symbols that signify important safety issues with
regards to operating or maintaining your Variety steamer.
warnInG
General warnInG. Indicates informa-
tion important to the proper operation of
the equipment. failure to observe may
result in damage to the equipment and/or
severe bodily injury or death.
warnInG
electrIcal warnInG. Indicates infor-
mation relating to possible shock hazard.
failure to observe may result in damage
to the equipment and/or severe bodily
injury or death.
caUtIOn
General caUtIOn. Indicates informa-
tion important to the proper operation of
the equipment. failure to observe may
result in damage to the equipment.
warnInG
HOt sUrface warnInG. Indicates
information important to the handling of
equipment and parts. failure to observe
caution could result in personal injury.
ImpOrtant safetY InfOrmatIOn
in addition to the warnings and cautions in this manual,
use the following guidelines for safe operation of the
unit.
• Read all instructions before using equipment.
• for your safety, the equipment is furnished with
a properly grounded cord connector. Do not
attempt to defeat the grounded connector.
• install or locate the equipment only for its intend-
ed use as described in this manual. Do not use
corrosive chemicals in this equipment.
• Do not operate this equipment if it has a dam-
aged cord or plug, if it is not working properly, or
if it has been damaged or dropped.
• this equipment should be serviced by qualified
personnel only. contact the nearest authorized
service agency for adjustment or repair.
• Do not block or cover any openings on the unit.
• Do not immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do not allow cord to hang over edge of table or
counter.
the following warnings and cautions appear
throughout this manual and should be carefully
observed.
• turn the unit off, disconnect the power
source, and allow unit to cool down before
performing any service or maintenance on the
unit.
• the procedures in this chapter may include
the use of chemical products. these chemi-
cal products will be highlighted with bold
face letters followed by the abbreviated Hcs
(Hazard communication standard). see
Hazard communication standard manual for
the appropriate material safety Data sheets
(msDs).
• the equipment should be grounded accord-
ing to local electrical codes to prevent the
possibility of electrical shock. It requires a
grounded receptacle with separate electrical
lines, protected by fuses or circuit breaker of
the proper rating.
• all electrical connections must be in accor-
dance with local electrical codes and any
other applicable codes.