American Power Conversion 3-in-1 Wireless Mobile Router 사용자 설명서
Modes
1-5
Use AP/Router mode in any of the following situations:
•
The Ethernet port is connected to a broadband modem rather than an Ethernet port.
•
There is permission for ONLY ONE (1) user to connect to the LAN or WAN, but multiple user connections are required. (In
AP/Router mode, the IP address on the Ethernet port is shared by all wireless clients.)
AP/Router mode, the IP address on the Ethernet port is shared by all wireless clients.)
Notes: 1. AP/Router mode uses a technology called “NAPT” (Network Address Port Translation), and NAPT may cause
problems with some complex multi-user communication applications. (There is no problem with common
services such as HTTP, FTP, E-mail, etc.). Should problems occur, try getting permission for all users to
connect to the LAN/WAN and use AP mode instead.
services such as HTTP, FTP, E-mail, etc.). Should problems occur, try getting permission for all users to
connect to the LAN/WAN and use AP mode instead.
2.
It is possible to connect to the APC 3-in-1 Wireless Mobile Router and change its configuration while it is
AP/Router mode.
The IP address used is the wireless LAN IP address, which can be set on the AP/Router Setup screen. The default value is 192.168.0.1
(the same as the Config mode IP address); however, this address can be modified as needed.
Note: Users must change the wireless LAN IP address if the LAN/WAN is using the address range 192.168.0.1 ~ 192.168.0.254.
(the same as the Config mode IP address); however, this address can be modified as needed.
Note: Users must change the wireless LAN IP address if the LAN/WAN is using the address range 192.168.0.1 ~ 192.168.0.254.
Config Mode
Config mode is used to perform any required configuration. In Config mode, the following settings are always used.
Connect to the APC 3-in-1 Wireless Mobile Router using either the wireless interface or the wired Ethernet connection. (the wired con-
nection is recommended). See Chapter 2, “” for information.
nection is recommended). See Chapter 2, “” for information.
Client Mode
Figure 4. Client Mode Configuration
Client mode is used with PC game consoles that have an existing Ethernet connection, In Client mode, the APC 3-in-1 Wireless Mobile
Router is connected to the Ethernet port of the computer (or other device), and will connect to a wireless LAN. This has the effect of
converting the Ethernet port to a wireless interface.
Note: In Client mode, the APC 3-in-1 Wireless Mobile Router is transparent; it has no IP address.
Router is connected to the Ethernet port of the computer (or other device), and will connect to a wireless LAN. This has the effect of
converting the Ethernet port to a wireless interface.
Note: In Client mode, the APC 3-in-1 Wireless Mobile Router is transparent; it has no IP address.
Password
The current password is Admin.
The default password is APC.
If the password is set, use admin as the login name.
If the password is set, use admin as the login name.
IP Address
192.168.1.1
(Mask:
255.255.255.0
)
DHCP Server
Enabled (for both Ethernet and wireless)
SSID
Default
Wireless Security
Disabled