Alesis Studio Interface MasterControl 참조 매뉴얼

 

 
„  Direct Monitoring   

When the MasterControl’s Direct Monitoring function is enabled, 
the signal you are hearing is taken directly from the MasterControl 
rather than from your DAW.  This allows you and your musicians 
to monitor the audio with no perceptible delay (latency).  Here, you 
can choose whether or not the Direct Monitoring signal will be blended with the signal from the DAW in 
each channel pair.   

 

You can adjust the blend of the Direct Monitoring signal with the 
DAW’s output by turning the DIRECT MON LEVEL knob.  At 0%, you 
will hear only the DAW’s output.  At 100%, you will hear the Direct 
Monitoring signal at an equal volume with the DAW’s output.  In the 
latter case, you may hear the input signal twice, with a short delay 
between each instance (“slapback”).  To hear the Direct Monitoring 
signal alone, simply turn off the input monitoring in your DAW. 

 
„ 

Pressing the MasterControl’s TALKBACK button will activate the 
built-in microphone above it, which you can use to talk to your 
musicians.  When you select “Yes,” the talkback signal will cause 
the DAW’s outputs to be muted (so talkback can “override” 
whatever else is coming over the headphones or monitors).  When you select “No,” the TALKBACK 
button will have no effect. 

 
„  Talkback Volume   

This setting determines the volume of the talkback signal. 

 

 
„  Optical Port 2 

 

The ADAT 2 / S/PDIF port on the rear panel of the MasterControl 
can accept either ADAT or optical S/PDIF information, which you 
can select here. 

 
„  Footswitch Setup   

When a footswitch is attached to the FOOTSWITCH connection 
on the rear panel of the MasterControl, it can be set to operate on 
the control surface or act as the TALKBACK button. 

 
„  Footswitch Polarity 

This setting changes the polarity of a connected footswitch.  The 
default is “Positive On,” meaning the pedal, when pressed, will 
activate or engage whatever it is set to.  Selecting “Negative On” 
will configure it such that it will be on as long as the pedal is not 
being pressed.  

 
„  Send SysEx 

Access this page to download a SysEx file to the MasterControl to 
change the configuration of its Editable Controls for its various 
Presets.  Select which Preset this will affect by turning the PUSH 
SELECT knob.  You can select any of the 12 Presets or the global 
configuration (“GLOBL"): 

DIR. MON ON 1/2 

 Yes

TALKBACK ON 1/2 

 Yes

TALKBACK VOLUME 

 10%

OPTICAL PORT 2 

 ADAT

FOOTSWITCH

 

SETUP 

Control Surface 

FOOTSWITCH

 

POLAR 

 Positive On 

SEND SYSEX PRE 1 

 Press to send