ADIC SNC 5100 사용자 설명서

Although the ADIC Management Console is the simplest and most efficient 
tool for updating firmware and saving/loading configurations, you can use the 
service terminal as an alternate method to perform these operations.

For more information, see the ADIC Management Console User Guide.

The ADIC Management Console service port supports Zmodem file transfers. 
The procedures below are specific for using the HyperTerminal program on the 
service terminal to transfer files. Other terminal emulation programs operate in 
a similar fashion. 

The Zmodem send and receive functions in some terminal emulation programs 
automatically issue the command string “

rz

” before sending a file and the 

command string “

sz

” before receiving a file. However, even if the program you 

are using automatically sends the “

rz

” command, manually issuing the 

command string “

rz

” before starting the transfer has no negative effect on the 

transfer.

From the Hyper Terminal window, at the 

SN60023 >

 command 

prompt, type 

rz

 and then press the Enter key.

From the HyperTerminal window select 

Transfer 

and 

Send 

File

.

From the 

Send File

 dialog enter the path and filename where the 

firmware file is located or click the 

Browse

 button and navigate to 

it. 

In the 

Protocol

 field, select 

Zmodem

 and click the 

Send

 button.

It will take several minutes for the file to be transferred. The 
Zmodem file send dialog will display the current status and it will 
close automatically when the file transfer has completed.

Wait for the Firmware Update Complete status message to be 
displayed on the service terminal indicating successful completion.

Reboot the SNC 5100 for the update to take effect.

For more information, see the