ADIC SNC 5100 사용자 설명서

Install optional utility software, if desired.

Perform steps 4 and 5 after the SNC 5100 is installed and connected to the host 
system. 

The SAN Explorer software is only available for hosts running the Windows 
NT or Windows 2000 operating systems. It allows you to view the LUN 
mapping through switches to which your SNC 5100 may be attached. 

It includes the Host Registration Service. The Host Registration Service 
provides the SNC 5100 with periodic host status information including the host 
name, host type and HBA. The default notification period is 15 minutes.

See the readme file on the CD-ROM for installation instructions. For software 
updates, visit www.adic.com.

The Host Registration Service is available without the SAN Explorer software 
for host operating systems other than Windows NT or Windows 2000. It 
provides the SNC 5100 with periodic host status information including the host 
name, host type and HBA. The default notification period is 15 minutes. 

See the readme file on the CD-ROM for installation instructions. For software 
updates, visit www.adic.com.

The SNC 5100 scans the SCSI buses after it boots. If you add or remove SCSI 
devices after the SNC 5100 has booted, it will not detect the changes until you 
invoke a SCSI rescan or reboot.

Before you turn on or restart the hosts that are connected to the SNC 5100, you 
must wait until the SNC 5100 has finished booting. You will know that the 
SNC 5100 has finished booting when the RDY LED on the user panel blinks at 
intervals of one second.