ADIC SNC 5100 사용자 설명서

Inform the system administrator that it is necessary to replace the 
Fibre Channel device connected to the SNC 5100 to resolve the 
Fibre Channel errors. 

Repeat this MAP, beginning with the section “Verify Fibre Channel 
Connections” on page 61, after replacing the external component.

Perform these steps if:

• RDY LED not blinking once per second after power has been on for one 

minute

• The SNC 5100 is not responding

• SNC 5100 processor memory fault detected

• SNC 5100 PCI bus parity error detected

• SNC 5100 PCI interface error detected

• The ADIC Management Console Server could not verify the connection 

to the SNC 5100

When the SNC 5100 is first powered on, the front-panel’s LEDs flash a variety 
of patterns as it performs the Power On Self Test (POST) and then starts 
booting. 

For more information, see “POST Error Codes” on page 197.

Within one minute, the SNC 5100 should have booted successfully and the 
Ready LED should be blinking once per second.

If the Ready LED is not blinking as expected, go to “Start MAP” on page 42.

Perform these steps if:

• The SNC 5100 generates Trap Event Codes 62, 64, or 67 (Inlet Air, Outlet 

Air, I/O Processor, or Fan have entered a Warning Range)