ADIC SNC 5100 사용자 설명서

Remove the Ethernet cable from the SNC 5100 and install the 
Ethernet loop back plug. 

From the service terminal, enter the 

diagBoot

 command. 

For more information, see “Entering Diagnostic Mode” on 
page 187.

Wait for the SNC 5100 to finish booting. 

Verify that the 

diagmode>

 prompt is displayed.

From the service port, enter the 

elTest

 command.

Example:

diagmode > elTest

==== Testing Ethernet ====

Init complete.

Ethernet OK

value = 0 = 0x0

 If the test fails, replace the SNC 5100. 

Go to “Before Removing or Replacing the Unit” on page 82.

Continue through “Replacing the SNC 5100” on page 84.

Exit this MAP.

If the test passes, remove the Ethernet loop back plug. 

Proceed to Step 29.

From the service terminal, enter the 

normalBoot

 command and 

wait for the SNC 5100 to finish booting. 

Reattach the Ethernet cable to the SNC 5100.

From the service terminal, enter the 

gateAddrGet

 command and 

write down the network gateway address that is displayed. 

For more information, see the 

Compare this address to the one provided by the network 
administrator.