Adcom URC-200 사용자 설명서

Basic Setup

You can start setting up your Automator using either the 
Pre-Programmed Method or the Learning Method. 
However, all the buttons of the Automator are setup at 
once with the Pre-Programmed Method, so it is usually 
faster than the one-button-at-a-time Learning Method.

Power on the A/V component you wish to setup, so that
you can test codes by sending power off commands.

Refer to the pre-programmed code tables on pages 
33 - 47 and write down the code numbers listed 
for your A/V component. The code numbers are 
listed by categories of devices, then by brand. See 
page 33 for a category list.

Press and hold both the MAIN and ENT (Enter) 
buttons for approximately three seconds. The top 
of the display will show “SETUP”. You are in 
SETUP mode now.

Note: You have 30 seconds to perform a step while you are 
in SETUP mode. If you don’t press a button within that time, 
the Automator will time out and return to normal operation.