Dot Hill Systems II 200 FC 사용자 설명서
Chapter 6 Checking LEDs
6-9
The I/O expansion module LEDs and their color definitions are shown in Table 6-5.
Note –
An SFP link status (L) LED is off if there is no connection or a failed
connection to this SFP.
6.3.3
Power Supply and Fan Module LEDs
The following figure shows the AC power supply and fan module.
Table 6-5 I/O Expansion Module LEDs
LED
Purpose
LED Color Definition
Activity
I/O activity of host
and disk ports
and disk ports
Off – Not busy (no I/O activity)
Blinking green – Busy (active I/O)
Blinking green – Busy (active I/O)
I/O module
Status of I/O
module
module
Solid green – Power-up successful and SES
chip has successfully read on-board
temperature and voltage sensors
Amber – Expansion unit powering up, or
failed voltage or temperature sensor
Off - Expansion unit is not powered up
chip has successfully read on-board
temperature and voltage sensors
Amber – Expansion unit powering up, or
failed voltage or temperature sensor
Off - Expansion unit is not powered up
SFP link (L)
SFP link status
Solid green – Active good FC Connection
Off – Empty or failed FC connection
Off – Empty or failed FC connection
SFP speed (S)
SFP speed status
Solid green – 2 Gbit
Off – 1 Gbit
Off – 1 Gbit
Table 6-6 Power Supply LEDs
Purpose LED
LED
Color
Definition
Monitors the DC output voltage
within tolerance specification.
Overcurrent protection shutting down
any voltage output is also displayed.
Voltage thresholds:
+5 VDC +/–.25 VDC
+12 VDC +/–.6 VDC
Current thresholds:
+5 VDC 35A
+12 VDC 25A
within tolerance specification.
Overcurrent protection shutting down
any voltage output is also displayed.
Voltage thresholds:
+5 VDC +/–.25 VDC
+12 VDC +/–.6 VDC
Current thresholds:
+5 VDC 35A
+12 VDC 25A
Solid green
Solid amber
Power supply and fans are
good.
good.
Failed: One or more output
voltages out of range or one
or both fans is rotating at less
than 4000 RPM.
voltages out of range or one
or both fans is rotating at less
than 4000 RPM.