Dot Hill Systems II 200 FC 사용자 설명서

Chapter 4 Connecting Your Array

4.11

Manually Setting a Static IP Address

You can manually set an array’s IP address using the controller’s firmware by typing 
values for the IP address, the subnet mask, and IP address of the gateway. If your 
network uses a Reverse Address Resolution Protocol (RARP) server or a Dynamic 
Host Configuration Protocol (DHCP) server to automatically configure IP information 
for devices on the network, you can specify the appropriate protocol instead of typing 
the information manually.

If you assign an IP address to an array to manage it out-of-band, for security 

reasons consider using an IP address on a private network rather than a publicly 
routable network.

To set the IP address, subnet mask, and gateway address of the RAID controller, 
perform the following steps. 

1. Access the array through the COM port on the I/O Controller module or through a 

telnet session to the existing IP address. 

2. From the controller firmware’s Main Menu, choose view and edit Configuration 

→ Communication Parameters → Internet Protocol (TCP/IP).

3. Select the chip hardware address and MAC address that is displayed.

4. Choose Set IP Address 

→ Address.

5. Type in the desired IP address, subnet mask (if it is not automatically supplied), and 

gateway address, choosing each menu option in turn, backspacing over any existing 
entries.
If your network sets IP addresses using a RARP server and you prefer using it to using 
a fixed IP address, type RARP rather than an IP address, and do not type in a subnet 
mask or gateway address. If your network sets IP addresses using a DHCP server and 
you prefer using it to using a fixed IP address, type DHCP rather than an IP address, 
and do not type a subnet mask or gateway address.

6. Press Esc to continue.

A confirmation prompt is displayed.

7. Choose Yes to continue.

You must reset the controller for the configuration to take effect. 

You are prompted to reset the controller.

Change/Set IP Address ?