Digidesign Control 24 사용자 설명서

Preamp Connections

For manageability, route each preamp output to 
its corresponding input number on a Pro Tools 
audio interface.

For more flexibility, connect these preamps to a 
patch bay instead of directly “hard-wiring” 
preamp channels to Pro Tools audio interface 
channels.

To connect Control|24 preamp output to 
Pro Tools:

1  

Connect a 25-pin D-Sub connector harness to 

one of the two LINE OUT TO PRO TOOLS (ei-
ther 1–8 or 9–16) connectors on the rear panel 
of Control|24.

2  

Connect the breakout cable for each preamp 

channel to the corresponding input on your 
Pro Tools audio interface, or to the appropriate 
inputs on your patch bay.

To connect a line-level signal:

1  

Turn the level control all the way down 

(counter-clockwise) as a safety precaution.

2  

Connect your line-level source to the bal-

anced 1/4-inch input jack on the rear of Con-
trol|24 that corresponds to your preamp 
number (1–16).

3  

Press the Source switch until the Line LED 

lights.

4  

Adjust the level control.

To connect an instrument-level signal:

1  

Turn the level control all the way down 

(counter-clockwise) as a safety precaution.

2  

Connect your Instrument source to the unbal-

anced 1/4-inch input jack on the rear of Con-
trol|24 labeled DI 1 or DI 2.

3  

Push the Source switch until the Instrument 

LED lights.

4  

Adjust the level control.

Phantom power is switchable in banks of eight 
microphone preamps. Turn off phantom power 
before connecting or disconnecting any micro-
phones, and consult manufacturer’s documen-
tation for condenser microphones.

To connect a microphone-level signal:

1  

Turn the level control all the way down 

(counter-clockwise) as a safety precaution.

2  

Make sure phantom power is not on.

3  

Connect your microphone or microphone-

level source to the balanced XLR input on the 
rear of Control|24 that corresponds to your 
preamp number (1–16).

4  

If using phantom powered microphones, 

push the 48v POWER switch on the rear of Con-
trol|24 for the bank of preamps you are using 
(either 1–8 or 9–16).

5  

Push the Source switch until the MIC LED 

lights.

6  

Adjust the level control.