Digidesign Control 24 사용자 설명서

Chapter 11: Recording

This chapter explains all the steps required to 
record into Pro Tools using Control|24. Instruc-
tions include configuring session parameters, 
assigning input and output routing, record-en-
abling tracks, and initiating recording from the 
transport. 

Starting the Recording 
Process

Before you start your first recording pass with 
Control|24, make sure you have configured the 
sample rate and other Session Setup parameters. 

Press STATUS (in the WINDOWS section) to dis-
play the Session Setup window on-screen. Refer 
to the Pro Tools Reference Guide for details about 
these parameters.

Make sure you have also followed all the other 
instructions for recording in the Pro Tools Refer-
ence Guide (Disk Allocation, MIDI Metro-
nome/Click, Countoff, and other preparation 
procedures). 

Assigning Channel Input

In order to select a source for channel input, you 
must be in the default “home” mode or Sends 
mode. Input and output assignments cannot be 
made while Pro Tools is playing or recording.

To assign an audio channel input from “home” or 
Sends mode:

1  

Press ASSIGN. The ASSIGN and ESC/CANCEL 

switches will both flash.

2  

Press INPUT. The INPUT switch LED will light. 

The scribble strip for each track will display ex-
isting input assignments. 

3  

Adjust the channel data encoder knob to 

scroll through the list of inputs. 

4  

When the abbreviated name of the input you 

want appears in the scribble strip, press the 
flashing switch directly below the data encoder 
knob to confirm your decision. 

5  

Adjust the data encoder knobs until the input 

you want on any other tracks is displayed. 

6  

Press the flashing switches directly below the 

data encoder knobs to confirm any other 
choices.

7  

Press ASSIGN or ESC/CANCEL to leave Input 

Assignment mode. The ASSIGN and ESC/CAN-
CEL switches will stop flashing to indicate that 
you have left the Assignment mode.