BMW 2009 535i Sedan 사용자 매뉴얼
Replacing components
244
Never touch the glass of new bulbs with
your bare fingers, as even minute
your bare fingers, as even minute
amounts of contamination will burn into the
bulb's surface and reduce its service life. Use a
clean cloth, napkin, etc., or hold the bulb by its
metal socket.
bulb's surface and reduce its service life. Use a
clean cloth, napkin, etc., or hold the bulb by its
metal socket.
<
A selection of replacement bulbs is available at
your BMW center.
your BMW center.
Only replace bulbs when cool, as other-
wise you may be burned.
wise you may be burned.
<
Whenever you perform any work on the
electrical system, turn off the systems/
electrical system, turn off the systems/
consumers involved to prevent short circuits
from occurring. To avoid possible injury or
equipment damage when replacing bulbs,
observe any instructions provided by the bulb
manufacturer.
from occurring. To avoid possible injury or
equipment damage when replacing bulbs,
observe any instructions provided by the bulb
manufacturer.
<
For bulbs for which changing is not
described, and for checking and adjusting
described, and for checking and adjusting
headlamp aim, please contact your BMW cen-
ter.
ter.
<
Light-emitting diodes LEDs
Light-emitting diodes installed behind translu-
cent lenses serve as the light source for many of
the controls and displays in your vehicle. These
light-emitting diodes, which operate using a
concept similar to that applied in conventional
lasers, are officially designated as Class 1 light-
emitting diodes.
cent lenses serve as the light source for many of
the controls and displays in your vehicle. These
light-emitting diodes, which operate using a
concept similar to that applied in conventional
lasers, are officially designated as Class 1 light-
emitting diodes.
Do not remove the covers, and never
stare into the unfiltered light for several
stare into the unfiltered light for several
hours, as irritation of the retina could result.
<
Halogen headlamps
The illustration shows the left-hand side of the
engine compartment.
engine compartment.
1 Cover cap for low beams
2 Cover cap for high beams
To remove the cover caps:
2 Cover cap for high beams
To remove the cover caps:
>
Low beams: press the detent, arrow, and
remove the cover from the guide.
remove the cover from the guide.
>
High beams: turn the cover cap to the left
and remove.
and remove.
Always wear gloves and eye protection –
the atmosphere within the H7 bulb is
the atmosphere within the H7 bulb is
pressurized. Otherwise there is a danger of inju-
ries if the bulb is accidentally damaged during
replacement.
ries if the bulb is accidentally damaged during
replacement.
<
Online Edition for Part no. 01 41 2 600 721 - © 08/08 BMW AG