BMW 2005 645Ci Convertible 사용자 매뉴얼

riv

g ti

uni

cat

iga

lity

Information regarding this is located near the
buckle latch of each safety belt.

To lock safety belt

Pull the entire length of the belt from the belt
retractor. Allow the reel to retract the belt
somewhat and engage the buckle, then tighten
the belt against the child-restraint system. The
retraction mechanism is now locked.

To unlock safety belt

Release the buckle, remove the child-restraint
system and allow the belt retractor to reel the
belt completely in.

Coupe: child-restraint system with
tether strap

If you use a child-restraint system with a tether
strap, two additional tether anchorage points
have been provided – refer to the arrows in the
illustration. Depending on the location selected
for sitting in the rear passenger area, attach the
tether strap to the corresponding anchorage
point to secure the child-restraint system, as
shown in the illustration below.

Each sitting position is fitted with a head
restraint.
The head restraint must be adjusted into the

lowest possible position. Pass the tether strap
over the head restraint.

Adjust the tether strap according to the
child-restraint manufacturer's instruc-

tions.

LATCH child-restraint fixing system

LATCH: Lower Anchor and Tethers for CHil-
dren.
The rear outer sitting positions are provided
with anchors for a LATCH child-restraint fixing
system.

To fit the LATCH child-restraint fixing
system, follow the operating and safety

instructions of the system manufacturer.

Access to anchorage points

The illustrations show the right rear seat as an
example. The outer anchorage points for the
LATCH child-restraint fixing system are identi-
fied by flags

The anchorage points for the LATCH child-
restraint fixing system are identified by but-
tons