Boss Audio Systems MR1400S 사용자 설명서

Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up 
properly and the unit and system work properly.
Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts 
can cause malfunctions.
Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the 
vehicle.
Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a 
sudden stop, like an emergency stop.
If installation angle exceeds 30° from horizontal, the unit might not give its optimum performance.

Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or 
from hot air, from heater, or where it would be subject to dust dirt or excessive vibration.
Be sure to remove the front panel before installing the unit.

This unit can be property installed either from “Front” (conventional DIN Front-mount) or “Rear”(DIN 
Rear-mount installation, utilizing threaded screw holes at the sides of the unit chassis). For details, 
refer to the following illustrated installation methods A and B.

1.  Dashboard
2.  Holder

After inserting the half sleeve into the 
dashboard, select the appropriate tab according 
to the thickness of the dashboard material and 
bend them inwards to secure the holder in 
place.

3.  Screw

30°

1

7

4

2

3

5

6

1.  Dashboard      
2.  Nut (5mm)     
3.  Spring washer
4.  Screw (5x15mm)  
5.  Screw        
6.  Support Strap
     Be sure to use the support strap to secure the 

back of the unit in place. The strap can be bent 
by hand to the desired angle.

7.  Plain washer

1

2

3

3