Boss Audio Systems Car Stereo System 610C 사용자 설명서

Installation using the screw holes on the sides of the unit.
Fastening the unit to the factory radio mounting bracket.

1.  Select a position where the screw 

holes of the bracket and the screw 
holes of the main unit become 
aligned (are fitted) and tighten the 
screws at 2 places on each side.

2.   Screw
3. Factory radio mounting bracket.
4. Dashboard or Console
5. Hook (Remove this part)

Note: the mounting box, outer trim ring,
and half-sleeve are not used for method 
B installation.

5

2

4

3

2

5

a.  Frame
b.  Insert fingers into the groove in the front 

of frame and pull out to remove the 
frame. (When re-attaching the frame, 
point the side with a groove down wards 
and attach it.)

c. Insert the levers supplied with the unit 

into the grooves at both sides of the unit 
as shown in figure until they click. Pulling 
the levers makes it possible to remove 
the unit from the dashboard.

Push the trim plate against the chassis until it is fitted. 
You must do this before you install the front panel, otherwise it can't be attached.

a

b

c

E - 4