Bosch Appliances Security Camera LTC9412/00 사용자 설명서

A

B

C

D

E

F

G

Bosch Security Systems

14 November 2003

        Description                               Part number                   Qty.
A     Clamp connector                        70-WPCR02                    1

B     12" ABS housing (black)            21-TOP123                     1

C     EMT connector                           70-WPCR01                   1

D     Camera bracket                           30-VL1361                     1

E      12" dome liner                            20-LNOP123                  1

F       Hartwell fastener                       95-FSPLO1(2)                3

G     12" OP clear dome                      RCOP123                       1
       

4.6.     Remove the set screw and drill an approximately 7/32" hole 
           at the point where the set screw dimples the conduit. Remove 
           the burrs and replace the set screw. 

4.7.     Attach the longer arm of the camera bracket to the end of 
           EMT connector using the clamp nut. Tighten (Figure 3).

Figure 3 Attach bracket arm to EMT connector

4.8.     Attach the other bracket arm using a carriage bolt, 5/16” 
           washer, lockwasher, and hex nut. The camera mounting side 
           may be facing either in or out (Figure 4).

Figure 4 Attach other bracket arm

4.9.     Connect the camera to the camera bracket and adjust to desired 
           viewing position. Tighten all connections. Complete wiring of
           the camera.

4.10.   Place the liner inside the dome. Hold the dome and liner up to 
           the housing and align the 3 Hartwell Fasteners in the dome to
           the match ing holes on the housing. Ensure that the cutout in 
           the liner is aligned with the camera. Once it’s correctly 
           positioned attach the dome to the housing by pressing the 
           Hartwell Fasteners into the fl ange of the dome (Figure 5). 

Figure 5 Attach the dome to the housing

Hartwell Fasteners

A

B

C

D

E

I

H

G

F

A     VL1361 bracket                         1

B     1/4-20 hex nut                            1

C     1/4" split lockwasher                  1

D     1/4" fl at washer                          1

E      FM2 bracket                               1

F       5/16" washer                             1

G     1/4-20 x 3/4" carriage bolt         1

H     1/4-20 x 1/2" hex bolt                1