Billy Goat HP3400 사용자 설명서
Part No 521302
Form No F101910A
8
HP Owner’s Manual
PACKING CHECKLIST
Your Billy Goat Mower is shipped from the factory in one crate, completely assembled except for the
handles and controls.
PUT OIL IN ENGINE BEFORE STARTING
ASSEMBLY
READ all safety instructions before assembling unit.
TAKE CAUTION
TAKE CAUTION
when removing the unit from the box.
NOTE: All item numbers called out in the assembly, operation, and maintenance sections of this manual can be
found on Parts List (pages 16-23).
1. Remove the unit from the box, be careful when removing it as there are cables that could be damaged by the
machine when rolling it out of the box.
2. Attach the upper handle assembly to the lower handle assembly using the hardware found in the holes located on
the lower handle.
3. Attach the throttle cable to the upper handle with the hardware located in the hole on the right side of the upper
handle.
4. Attach the drive and blade cables levers to the upper handle using the hardware provided. Note: The blade cable
will also need to be attached to the console. To attach it run one of the nuts off of the thread and slide the cable
through the slot then run the nut back down and tightening it. The standard setting should be positioned near the
bottom of the barrel of the cable. For fine tuning the lever see page 14 for cable tension adjustments.
5. Make sure that all cables and levers function properly. They should not kink or bind in anyway.
6. Using the Ty-wraps provided in the hardware bag, secure the cables. Make sure that no cable is coming into
contact with a moving surface such as the wheels.
7. Fill with oil and gas to the proper level and the unit is ready to mow.
8. Read the rest of the operator’s manual.
found on Parts List (pages 16-23).
1. Remove the unit from the box, be careful when removing it as there are cables that could be damaged by the
machine when rolling it out of the box.
2. Attach the upper handle assembly to the lower handle assembly using the hardware found in the holes located on
the lower handle.
3. Attach the throttle cable to the upper handle with the hardware located in the hole on the right side of the upper
handle.
4. Attach the drive and blade cables levers to the upper handle using the hardware provided. Note: The blade cable
will also need to be attached to the console. To attach it run one of the nuts off of the thread and slide the cable
through the slot then run the nut back down and tightening it. The standard setting should be positioned near the
bottom of the barrel of the cable. For fine tuning the lever see page 14 for cable tension adjustments.
5. Make sure that all cables and levers function properly. They should not kink or bind in anyway.
6. Using the Ty-wraps provided in the hardware bag, secure the cables. Make sure that no cable is coming into
contact with a moving surface such as the wheels.
7. Fill with oil and gas to the proper level and the unit is ready to mow.
8. Read the rest of the operator’s manual.
Boxing Parts
Checklist
Checklist
Briggs and
Stratton Intek
Parts Bag
checklist
Parts Bag
checklist
Ty-wrap qty 4
P/N-900407
PARTS BAG &
LITERATURE ASSY
LITERATURE ASSY
Warranty card P/N- 400972, Owner’s Manual P/N-521302.