Behringer Autocom Pro-XL MDX1600 사용자 매뉴얼

MULTICOM PRO-XL MDX4600/COMPOSER PRO-XL MDX2600/AUTOCOM PRO-XL MDX1600 User Manual

MULTICOM PRO-XL MDX4600

Ch1

Hi

Input

Input

Mixer

Power amplifiers

L

R

Ch2

Low

SUPER-X PRO CX2310

Ch3

Ch1 Ch2 Ch3 Ch4

Hi

Ch4

Low

Fig. 4.3: Multi-band compression with the MDX4600

Each device requires one rack unit for installation in a 19" rack. Please allow an 

additional 4" of rack depth for the rear panel connectors.
Be sure that there is enough air space around the unit for cooling. To avoid 

overheating, do not place the unit on power amps, for example.

You will need a large number of cables for the different applications. 

The illustrations below show the wiring of these cables. Be sure to use only 

high-grade cables.
The audio connections of the MULTICOM PRO-XL, AUTOCOM PRO-XL and 

COMPOSER PRO-XL are electronically balanced to avoid hum problems.
You can, of course, also connect unbalanced devices to the balanced inputs/

outputs. Either use mono plugs, or link the ring and shaft on stereo plugs 

(or pins 1 and 3 in the case of XLR connectors).

For unbalanced use, pin 1 and pin 3 have to be bridged

1 = ground/shield

2 = hot (+ve)

3 = cold (-ve)

1

2

3

1

2

3

Fig. 5.1: XLR connections

Fig. 5.2: 1/4" TS connector

For connection of balanced and unbalanced plugs,

ring and sleeve have to be bridged at the stereo plug.

Fig. 5.3: 1/4" TRS connector

Connect the insert send with the input and the

insert return with the output of the effects device.

Fig. 5.4: 1/4" TRS connector for insert applications