Bay Technical Associates 525H 사용자 설명서
#
Multiports power-up in the verbose or menu-driven mode. Only in the
menu-driven mode can changes be saved permanently in non-volatile
memory. Non-verbose mode allows the host device to configure the
multiport be sending an ASCII character string which may be
preferable in some instances. This mode applies only to configuration
and does not affect operations. The non-verbose mode is basically
the same as the verbose mode, except that no menus are sent from
the multiport. Also, changes made in the non-verbose mode are not
saved in non-volatile memory and will be lost upon power-down,
whereupon the power-up default configuration will again be in effect.
menu-driven mode can changes be saved permanently in non-volatile
memory. Non-verbose mode allows the host device to configure the
multiport be sending an ASCII character string which may be
preferable in some instances. This mode applies only to configuration
and does not affect operations. The non-verbose mode is basically
the same as the verbose mode, except that no menus are sent from
the multiport. Also, changes made in the non-verbose mode are not
saved in non-volatile memory and will be lost upon power-down,
whereupon the power-up default configuration will again be in effect.
The non-verbose mode is selected by sending to the host port of the
multiport the control character (factory default is
multiport the control character (factory default is
Control-T) followed
by ASCII capital I.
You may now reconfigure by selecting numbers from these menus:
A. MAIN MENU
Set Serial Port Configuration...........2
Set Message Terminate Character.........3
Set Data Block Length...................4
Set Control Character...................5
Set Mode of Operation...................6
Exit....................................X
Set Serial Port Configuration...........2
Set Message Terminate Character.........3
Set Data Block Length...................4
Set Control Character...................5
Set Mode of Operation...................6
Exit....................................X
B. SET SERIAL PORT CONFIGURATION MENU
Enter port number and
Enter port number and
Carriage Return
.
Exit/Save........................1
Set baud rate....................2
Set word size....................3
Set stop bits....................4
Set parity.......................5
Set Xon/Xoff.....................6
Set baud rate....................2
Set word size....................3
Set stop bits....................4
Set parity.......................5
Set Xon/Xoff.....................6
a) SET BAUD RATE MENU
110..................1
135..................2
300..................3
600..................4
1200.................5
2400.................6
4800.................7
9600.................8
110..................1
135..................2
300..................3
600..................4
1200.................5
2400.................6
4800.................7
9600.................8