Bay Technical Associates 350 사용자 설명서
Using the BayStack 350 10/100 Autosense Switch
2-8
893-00992-B
Wall Mounting
You can mount the BayStack 350 switch on any wall that can safely support the
weight of the device and attached cables (see “Site Preparation” on
weight of the device and attached cables (see “Site Preparation” on
safety considerations). The BayStack 350 switch can be mounted with or without
the rubber footpads.
the rubber footpads.
Before You Begin
Before mounting the BayStack 350 switch on a wall, note the following
considerations:
considerations:
•
The BayStack 350 switch must be wall mounted with the front panel facing
upward, as shown in Figure 2-4.
upward, as shown in Figure 2-4.
•
Because the LEDs are located on the front panel, you should position the
switch at a height that allows the LEDs to be visible at all times.
switch at a height that allows the LEDs to be visible at all times.
•
Do not let the attached port cables hang freely from the port connectors.
Install plastic cable clamps to support and dress the cables.
Install plastic cable clamps to support and dress the cables.
•
Because wall composition varies at each site, wall-mounting screws are not
supplied. You should choose the appropriate mounting hardware for your wall
composition.
supplied. You should choose the appropriate mounting hardware for your wall
composition.
•
A common and safe method for attaching devices to most walls is to attach
the device to a piece of plywood (at least 0.5 in. thick) that is firmly secured to
the wall, preferably to the wall studs.
the device to a piece of plywood (at least 0.5 in. thick) that is firmly secured to
the wall, preferably to the wall studs.
350fbk.book Page 8 Wednesday, July 9, 1997 4:51 PM